Is there a wiring diagram available for the washer and wiper motor? On my FX4, the washing does not cycle and the wipers have stopped working. swapped out the multifunction switch for an OEM stalk, a used but well-tested motor, and nothing else. I looked at fuse 49, which is said to be the only fuse for the relay 62 and the wiper motor. I do not have access to wiring diagrams for this, therefore I am stuck. Is there another fuse that might be blown in this case?
I am deling with the same issue…were you able to figure it out?? Please say yes…lol pulling my hair out…lol
After thoroughly researching the issue with my 2014 Ford F-150’s wiper motor, it seems there are a few potential causes and troubleshooting steps I can try. First, I checked the fuse labelled for the wiper motor, which is Fuse #49, and found it to be in good condition. I also tested Relay #62, which is associated with the wiper system, and it appears to be functioning properly as well. However, the search results indicate there may be another fuse, Fuse #10, that could also be related to the wiper motor. I’ll need to locate that one and test it. Additionally, the wiring diagram suggests checking the ground connection at G102, as poor ground could be causing the issue. I may need to clean the ground point or replace the wiring if there’s a problem there. Lastly, the information points to potentially replacing the wiper motor itself, as the motor may have failed even after swapping it out once already. I’ll methodically work through these troubleshooting steps to isolate the root cause and get my 2014 F-150’s wiper system back up and running. The key seems to be thoroughly checking all the electrical components involved.